Home › Paint Calculator › This size

How Much Paint for a 14×16 Room with a 9 ft Ceiling?

A 14 × 16 room with a 9 foot ceiling needs this much paint per coat, with doors and windows already deducted. Here is the answer, plus a calculator you can adjust if your measurements are slightly different.

Answer: 3 gallons

How it changes with coats

Same area, different coats:

Coats	1	2	3
Paint needed	2 gallons	3 gallons	5 gallons
Openings deducted	51 ft²	51 ft²	51 ft²

What a 14×16 room with a 9 ft ceiling actually involves

At 14×16 ft this is the size of a typical bedroom, home office or dining room. Stripping out the openings leaves about 489 ft² of wall to cover, and at 2 coats that is 978 ft² of paint. It is a comfortable one-person weekend job, and the only real decision is whether to roll or spray.

Four walls give 540 ft² of raw surface. After 1 door and 2 windows — deducted at 21 ft² and 15 ft² each — you are painting 489 ft². At 2 coats and 350 ft² per gallon, that rounds up to 3 gallons. Everything below comes from those figures.

Where the square footage goes

Surface	Area	Notes
Two 16 ft walls	288 ft²	16 ft × 9 ft each
Two 14 ft walls	252 ft²	14 ft × 9 ft each
Walls, gross	540 ft²	perimeter of 60 ft × 9 ft ceiling
Doors deducted	21 ft²	1 × 21 ft²
Windows deducted	30 ft²	2 × 15 ft²
Paintable wall	489 ft²	what the 3 gallons actually covers

The footprint is 14 ft × 16 ft, so the two 16 ft walls are the long runs and the two 14 ft walls are the short ends. The long walls roll quickly; the short ends carry the corners and usually the door, so allow more cutting-in time per foot there.

At 9 ft the top of the wall sits at the awkward height where a stepladder is a stretch but scaffolding is overkill; an extension pole and a stable platform are the practical answer.

Working at a 9 ft ceiling

At 9 ft the ceiling line is out of reach from the floor but too low to justify scaffolding. The practical setup is a 6 ft platform stepladder plus an extension pole on the roller. Budget about 8 repositioning moves around the 60 ft perimeter — more than an 8 ft room, and it is the top few inches where a rushed cut-in shows.

One coat, two coats, three coats

Most repaints need two coats, but the quantity changes sharply with each pass, so it is worth seeing the three side by side:

Coats	Paint required	Typical use
1	2 gallons	same colour, already primed, or a touch-up
2	3 gallons	the standard: full colour change and durability
3	5 gallons	dark over light, bare drywall, or a deep accent colour

This page is worked through at 2 coats, which is why the answer box says 3 gallons. If you are painting a dark wall back to a light colour, treat two coats as the minimum and buy for three — running out mid-wall is worse than a spare can.

Ceiling, trim and primer — the extras

The calculator covers walls only. If you are doing the whole room, these are the add-ons:

Item	Quantity	Notes
Ceiling	224 ft² — about 1 gallon per coat	14 ft × 16 ft flat area, priced as a separate surface
Baseboard and trim	57 lin ft — about 1 quart	trim paint covers roughly 100 linear ft per quart
Primer	2 gallons	one coat over 489 ft²; needed over bare drywall or a dark colour

Primer is usually cheaper per gallon than colour and does two jobs: it seals bare drywall so the topcoat does not get sucked in, and it lets a colour change cover properly in two coats instead of three. Skimping on primer is the most common reason a two-coat job turns into a four-coat job.

Buying the paint

Option	Quantity	Estimated cost
Single gallons	3	$114
5 gallon pail	not worth it below 5 gal	—

At 3 gallons you are below the level where a 5 gallon pail pays off, so buy single cans. Buy them all in one trip and check the batch codes match: two cans from different batches can be slightly different tints, and a wall repainted from a mismatched can shows the seam forever.

Costs assume $38 per gallon and $165 per 5 gallon pail of mid-range interior paint ($30 per gallon of primer, $16 per quart of trim enamel). Brand, sheen and finish move these numbers a lot, so treat them as a planning figure rather than a quote.

Common questions

How much paint for a 14×16 room?

3 gallons of wall paint. That covers 978 ft² of surface at 2 coats, after deducting 1 door and 2 windows from the 540 ft² of wall. A 1-coat refresh would take 2 gallons and a 3-coat job 5.

Does that include the ceiling and trim?

No. The 3 gallons is for the four walls. The ceiling adds 224 ft², about 1 gallon per coat, and the baseboard and trim come to roughly 57 linear ft, about 1 quart of enamel. Add them to the order if you are doing the whole room.

How much primer do I need for this room?

About 2 gallons for one coat over the 489 ft² of paintable wall. Primer is only needed over bare drywall, fresh patching or a big colour change — over a similar existing colour you can skip it and go straight to two coats of paint.

How long between coats for a room this size?

Water-based interior paint is usually recoatable in two to four hours at normal room temperature. In a room this size, plan to finish a full pass before starting the next — that naturally spaces the coats and keeps the finish even. Cold, humid weather stretches the wait; check the can rather than guessing.