MaterialCalc

Home › Gravel Calculator › This size

How Much Gravel for 30×12 ft at 6 Inches Deep?

30 ft × 12 ft at 6 inches deep needs 6.67 yd³ of gravel — about 9.33 tons, or 374 bags of 50 lb stone. Bulk is usually near $300 before delivery; bags run about $2,244. Change the numbers below and the figures follow.

Answer: 6.67 cubic yards

How many tons of gravel for 30×12 ft?

MeasureFigure
Area360 ft²
Depth6 in
Volume180.0 ft³ (6.67 yd³)
Weight @ 1.4 t/yd³9.33 tons
50 lb bags374 bags (~$2,244)
Bulk loose6.67 yd³ (~$300 before delivery)

At 9.33 tons, plan on bulk. That is roughly 14 half-yard pickup trips if you self-haul — or one dump delivery. Watch the payload sticker: a half-ton truck is only rated for about 1,000 lb.

6 in is base-course depth. Place it in lifts of 4 in or less and compact each one, or the lower half stays loose and ruts.

One cubic yard at this depth covers about 54 ft² — useful when you are sizing a longer drive from a per-yard quote.

If the area is a different size

Same 6 inch depth:

SizeGravel at 6 in
12×122.67 yd³ · 3.73 tons
20×103.70 yd³ · 5.19 tons
30×105.56 yd³ · 7.78 tons
20×207.41 yd³ · 10.37 tons
40×128.89 yd³ · 12.44 tons

How it changes with depth (in)

Same area, different depth (in):

Depth (in)246
Gravel needed2.22 cubic yards4.44 cubic yards6.67 cubic yards
Depth2 in4 in6 in

What 30×12 ft at 6 inches deep actually involves

30×12 ft at 6 in is 9.33 tons, so this is a delivery rather than a collection. The order is roughly 1 full dump-truck load — more than any pickup should carry. Book the delivery and decide where the truck dumps before it arrives: on a driveway it will be in the way, on the lawn it will leave a crater, and on the finished area it is in the wrong place forever.

The area is 360 ft². At 6 in deep that is 180.0 ft³ of stone, or 6.67 yd³. Gravel is sold by weight, so the number that matters at the yard is 9.33 tons, assuming the usual ≈1.4 tons per cubic yard. Everything below is worked out from those figures.

Base course or surface dressing?

6 in is base-course depth for a driveway or parking area. Stone this deep only works if it is placed in two lifts and compacted between them — dumping 6 in at once leaves the lower half loose, and the surface will rut the first time a loaded vehicle crosses it. Below the gravel you still want geotextile or a compacted sub-base on soft ground.

Match the depth to the job rather than picking a number:

UseDepthWhat goes below
Decorative bed, top-up2 inwoven weed fabric over soil
Garden path, foot traffic2–4 incompacted sub-base or fabric
Driveway surface layer2–3 in4–6 in compacted crushed base
Driveway base, bare ground6 in+geotextile on soft soil

Ordering: bags, tons or trucks

OptionQuantityEstimated cost
50 lb bags374 bags$2,244
Bulk, loose6.67 yd³ — 9.33 tons$300
Pickup collection14 trips$300 + fuel
Dump truck delivery1 load$300 + delivery
Perimeter edging89 lin ft30 ft + 12 ft doubled, plus 5% for corners

The area is 30 ft × 12 ft, so the longest single run is 30 ft and the short side is 12 ft. Rake in strips along the long run rather than across it — you will do fewer, longer passes and the surface comes out more even. Perimeter edging is about 89 linear ft.

Bulk comes to about $300 for 6.67 yd³ against $2,244 in 50 lb bags — a large saving that gets bigger as the order grows. Bagged stone only makes sense when the quantity is tiny or the truck cannot reach the spot.

Costs assume $6 per 50 lb bag and $45 per cubic yard loose. Weight uses 1.4 US tons per cubic yard, though decorative and lighter stone runs nearer 1.25 and dense crushed rock up to 1.45. Delivery and minimum-order charges are local, so get a delivered price before you decide.

Laying gravel so it stays put

  1. Strip the topsoil. Gravel spread over grass or soft earth sinks within a season — the soil pumps up through it and the surface turns to mush.
  2. On soft ground lay a woven geotextile before any stone. It separates the stone from the soil so the two do not mix, and it does most of the work of keeping the surface firm.
  3. Build in lifts. Compact each ≤4 in layer with a plate compactor before the next, and water it lightly as you go so the fines bind.
  4. You are moving 9.33 tons — about 6.67 yd³. Work from the far end back toward the entrance so you are not walking on the finished surface.
  5. Edge it, or it will migrate into the lawn. Timber, steel strip or a shallow concrete curb all work; without an edge the stone spreads a little further every month.
  6. Weed fabric belongs under decorative beds, not under a driveway base: traffic tears it, and once it rucks it creates a soft spot right where you need the surface firmest.

Common questions

How much gravel do I need for 30×12 ft at 6 inches?

About 6.67 cubic yards, or 9.33 tons. That is 360 ft² at 6 in deep (180.0 ft³). Divide by 27 for yards, then multiply by 1.4 for tons.

How many 50 lb bags of gravel for 30×12 ft?

374 bags. Each bag is 50 lb, so 9.33 tons is 18667 lb of stone. Bags make sense only when the order is small or access is tight.

Is bulk cheaper than bags for this job?

Yes on material: about $300 loose versus $2,244 in bags. Add delivery, then compare — bulk still wins at this size for most yards.

How deep should gravel be here?

This page is calculated at 6 inches. Use 2 in for a decorative finish, 4 in for a path or surface layer, and 6 in compacted in lifts for a driveway base on bare ground.

How many pickup loads is 9.33 tons?

About 14 trips if you allow half a cubic yard per trip. Do not fill past the payload rating on the door sticker.

Other sizes