MaterialCalc

Home › Gravel Calculator › This size

How Much Gravel for 20×20 ft at 4 Inches Deep?

20 ft × 20 ft at 4 inches deep needs 4.94 yd³ of gravel — about 6.91 tons, or 277 bags of 50 lb stone. Bulk is usually near $222 before delivery; bags run about $1,662. Change the numbers below and the figures follow.

Answer: 4.94 cubic yards

How many tons of gravel for 20×20 ft?

MeasureFigure
Area400 ft²
Depth4 in
Volume133.3 ft³ (4.94 yd³)
Weight @ 1.4 t/yd³6.91 tons
50 lb bags277 bags (~$1,662)
Bulk loose4.94 yd³ (~$222 before delivery)

At 6.91 tons, plan on bulk. That is roughly 10 half-yard pickup trips if you self-haul — or one dump delivery. Watch the payload sticker: a half-ton truck is only rated for about 1,000 lb.

4 in suits a path or a driveway surface on an existing base. On bare soil for cars, step up to 6 in compacted in lifts.

One cubic yard at this depth covers about 81 ft² — useful when you are sizing a longer drive from a per-yard quote.

If the area is a different size

Same 4 inch depth:

SizeGravel at 4 in
20×102.47 yd³ · 3.46 tons
30×103.70 yd³ · 5.19 tons
30×124.44 yd³ · 6.22 tons
40×125.93 yd³ · 8.30 tons
24×247.11 yd³ · 9.96 tons

How it changes with depth (in)

Same area, different depth (in):

Depth (in)246
Gravel needed2.47 cubic yards4.94 cubic yards7.41 cubic yards
Depth2 in4 in6 in

What 20×20 ft at 4 inches deep actually involves

20×20 ft at 4 in is 6.91 tons, so this is a delivery rather than a collection. The order is roughly 1 full dump-truck load — more than any pickup should carry. Book the delivery and decide where the truck dumps before it arrives: on a driveway it will be in the way, on the lawn it will leave a crater, and on the finished area it is in the wrong place forever.

The area is 400 ft². At 4 in deep that is 133.3 ft³ of stone, or 4.94 yd³. Gravel is sold by weight, so the number that matters at the yard is 6.91 tons, assuming the usual ≈1.4 tons per cubic yard. Everything below is worked out from those figures.

Base course or surface dressing?

4 in is a path and topping depth. It is enough to keep a walking route clean and mud-free, and enough to refresh the surface of a driveway that already has a sound base. For a driveway carrying cars, 4 in on bare ground will rut and disappear into the soil within a season unless it sits on compacted crushed base.

Match the depth to the job rather than picking a number:

UseDepthWhat goes below
Decorative bed, top-up2 inwoven weed fabric over soil
Garden path, foot traffic2–4 incompacted sub-base or fabric
Driveway surface layer2–3 in4–6 in compacted crushed base
Driveway base, bare ground6 in+geotextile on soft soil

Ordering: bags, tons or trucks

OptionQuantityEstimated cost
50 lb bags277 bags$1,662
Bulk, loose4.94 yd³ — 6.91 tons$222
Pickup collection10 trips$222 + fuel
Dump truck delivery1 load$222 + delivery
Perimeter edging84 lin ft20 ft + 20 ft doubled, plus 5% for corners

The area is square at 20 ft × 20 ft, so there is no long run and no awkward narrow end: spread it in even passes, working back toward the entrance. The perimeter is 84 linear ft once you allow 5% for corners.

Bulk comes to about $222 for 4.94 yd³ against $1,662 in 50 lb bags — a large saving that gets bigger as the order grows. Bagged stone only makes sense when the quantity is tiny or the truck cannot reach the spot.

Costs assume $6 per 50 lb bag and $45 per cubic yard loose. Weight uses 1.4 US tons per cubic yard, though decorative and lighter stone runs nearer 1.25 and dense crushed rock up to 1.45. Delivery and minimum-order charges are local, so get a delivered price before you decide.

Laying gravel so it stays put

  1. Strip the topsoil. Gravel spread over grass or soft earth sinks within a season — the soil pumps up through it and the surface turns to mush.
  2. On soft ground lay a woven geotextile before any stone. It separates the stone from the soil so the two do not mix, and it does most of the work of keeping the surface firm.
  3. Build in lifts. Compact each ≤4 in layer with a plate compactor before the next, and water it lightly as you go so the fines bind.
  4. You are moving 6.91 tons — about 4.94 yd³. Work from the far end back toward the entrance so you are not walking on the finished surface.
  5. Edge it, or it will migrate into the lawn. Timber, steel strip or a shallow concrete curb all work; without an edge the stone spreads a little further every month.
  6. Weed fabric belongs under decorative beds, not under a driveway base: traffic tears it, and once it rucks it creates a soft spot right where you need the surface firmest.

Common questions

How much gravel do I need for 20×20 ft at 4 inches?

About 4.94 cubic yards, or 6.91 tons. That is 400 ft² at 4 in deep (133.3 ft³). Divide by 27 for yards, then multiply by 1.4 for tons.

How many 50 lb bags of gravel for 20×20 ft?

277 bags. Each bag is 50 lb, so 6.91 tons is 13827 lb of stone. Bags make sense only when the order is small or access is tight.

Is bulk cheaper than bags for this job?

Yes on material: about $222 loose versus $1,662 in bags. Add delivery, then compare — bulk still wins at this size for most yards.

How deep should gravel be here?

This page is calculated at 4 inches. Use 2 in for a decorative finish, 4 in for a path or surface layer, and 6 in compacted in lifts for a driveway base on bare ground.

How many pickup loads is 6.91 tons?

About 10 trips if you allow half a cubic yard per trip. Do not fill past the payload rating on the door sticker.

Other sizes